But if you are pretty good with geometry and mechanically inclined it's all pretty obvious.įirst of all, I applaud you for your sense of adventure in creating something different and unique. I'm sure if you search around though someone has already written a tutorial. It's too complicated to go into great detail and type out on here. It's not all that hard to figure out how to do all that stuff, but then again it's not that simple. You also need to pay attention to the alignment of the neck so that the bridge and strings don't end up off-center. (That's going to take some special measuring and a bit of math to work out if you will need to move the bridge and by how far) What fret position does the butt of the neck lie on and how much distance is that from the average saddle position. (if you are good with imaging software you can scale up builders drawing and print out a paper template to compare.Īnd last but not least. It'll either be rounded or flat and it needs to be close enough to fit in there. If it has a fretboard extension doublecheck theres not too much depth in the pocket that there is still clearance for it between the face of the body and/or pickguard. If it's a used neck, beware of possible truss rod damage.

You can plan on drilling, dowling and re-drilling them from the start. The screw mounting holes are almost certainly not going to align. That comes with the territory and half the time you will need to sand the sides of the neck to fit. Most of the time a neck with be ever so slightly too large or small for a perfect snug fit. Any neck builder ought to be able to provide specs on what they build. A cheap plastic one will do, but you can also use a simple ruler.įrom there, you need to search the internet for necks. I recommend using a standard 6' dial caliper because it makes measuring stuff like this easy, precise and you can use it for so many things ight down to measuring string gauges and nut heights, etc. The depth of pocket ought to be uniform throughout from face of the body to the bottom of the pocket. The length of pocket is measured from the center where the butt of the neck joins the body out to the lip. The width is measured from one side to the other at the bottom (widest part) of the pocket. It probably doesn't because even certain years and models of Fenders don't adhere exactly to Fender specs.

Well the neck pocket measurements you need to obtain yourself because Charvel, being such an off-brand may or may not align to standard fender specs.

Which nut fits charvel